Digiweigh DWP-L Series Bedienungsanleitung

Drum/Wheelchair Scale DWP-1000L (1000Lb/0.1Lb) DWP-2000L (2000LB/1LB) DWP-101(Indicator) User Manual

9 Use the directional keys to move around in the User Menu Chart. 1. To move to a new “A” heading, use the TARE (left) or PRINT (right) key to

10 NAME/CODE DESCRIPTION CODE/VALUE H1 Graduation Specifies number of full-scale graduations. Value should be consistent with legal re

11 NAME/CODE DESCRIPTION CODE/VALUE H9 Display Divisions Determines the desired weight increments. Value should be co

12 User Menu Descriptions This section provides more detailed descriptions of the selections found in the User Menu Chart. Factory-set d

13 NAME/CODE DESCRIPTION CODE/VALUE A1 Baud Rate Selects the baud rate for data transmission through the serial port. 120

14 NAME/CODE DESCRIPTION CODE/VALUE A6 Serial Port Mode Select the mode of the RS-232 serial port;

15 Calibration The indicator is calibrated by following the procedures embedded in H16 (Zero) an

16 8. Repeat 2-4 using different test weight value and End C3 then revert to H17. 9. If the calibration was successful, revert to H17. 10. If t

17 Key-in span calibration value Note: This procedure is intended for emergency use only in the case of non-volatile memory loss.

18 Operation Display Display Details Keyboard Units – This key toggles the indicator among t

1 Content CHAPTER 1 MAIN SPECIFICATION CHAPTER 2 INSTALLATION CHAPTER 3 INDICATOR

19 Tare -This key is used to establish a Tare provided the following conditions are met: 1 The indicator is not at or below Gross zero. 2 T

20 Appendix A Error information: display mode description □□□□□□ weighing mode overload or without ADC input ERR0 H17 Span Calib. The calibrat

2 Chapter 1 Main Specification 1. Model: DWP-L SERIES Drum/Floor Scale 2. Accuracy: GradeⅢ, n=10000 3. Sample Rate: 10 times/second 4. Load cel

3 b. Take out the scale feet (total 4 feet packed in the box inside the scale base) c. Screw each foot ontothe load cell at each corner of t

4 d. Take out the indicator from Box 2. Plug the scale serial cable into the socket on the back of the indicator. And use a screw driver to tigh

5 Chapter 3 Indicator Front and back view of the indicator Front: Back:

6 Connections Connection with Weigh Platform The indicators mounted in an ABS enclosure ship with a

7 Configuration The indicator contains two main setup menus: The Setup (“H”) menu, which configures th

8 Setup Menu Chart The User (“A”) menu sub-menus appear when scrolling left or right from the “H” menu. Some selections shown are not availa