Digiweigh DWP-102E Bedienungsanleitung

DWP-102E Weighing Indicator User’s Guide

- - 8 “P12 KB”: When “on”, keyboard is pressed with sound. “P13 UT”: Unit setting. Lb, U1 or U2 is optional, which could be “ON” or “OFF” through pre

- - 9 SECTION 6 ERROR CODES ERROR CODES DESCRIPTION RESOLUTION - - OL - - Over range Remove weight from the scale. Err

Table of Contents SECTION 1 INTRODUCTIONS………………………………………………………………1 1.1 Introduction……………………………………………………………………………………1 1.2 Specification……………………………

- - 1 SECTION 1 INTRODUCTIONS 1.1 Introduction The indicator provides an accurate, fast and versatile series of general purpose weighing indicator w

- - 2 Power on/off the indicator. ZERO Key 1) When self-checking, Press ZERO Key to enter parameter setting; 2) Set the zero point f

- - 3 SECTION 3 OPERATIONS 3.1 Power on/off Press ON/OFF Key to power on the Indicator and the indicator self-checks, then goes into the weighing st

- - 4 The scale should be tare a second time if another is added to the first one. Again only the weight added after tare will be displayed. When the

- - 5 weights, and then total weight. Clear the accumulated weight from memory: Press ZERO Key during display of the nos. of weights and

- - 6 indicator HI will be on, while lower than the low-limit indicator LO will be on. Otherwise indicator HI & LO will be both on. Mode

- - 7 KEY 5 To set the MOD Key for animal weighing parameters setting. “F4 CHK”: Check-weighing setting Options: BEEP 1/2/3. “F5 Brt”: Adjust